Shift to P
This message is displayed if you try to turn off the vehicle without the gear in the P (Park) position.
If this occurs, the Engine Start/Stop button turns to the ACC position.
Low key battery
When the Engine Start/Stop button is pressed to turn OFF the engine, this message may be displayed. This message indicates that the internal battery of the Smart Key is low. Consider replacing the Smart Key internal battery.
Press START button while turning wheel
This message is displayed if the steering wheel does not unlock normally when the Engine Start/Stop button is pressed. You should press the Engine Start/Stop button while turning the steering wheel right and left.
Check steering wheel lock system
This message is displayed if the steering wheel does not lock normally while the Engine Start/Stop button is pressed to the OFF position.
Press brake pedal to start engine
This message is displayed if the Engine Start/Stop button changes to the ACC position twice by pressing the button repeatedly without depressing the brake pedal.
You can start the vehicle by depressing the brake pedal and then pressing the Engine Start/Stop button.
Key not in vehicle
This message is displayed if the smart key is not in the vehicle when you leave the vehicle with the Engine Start/Stop button in the ON or Start position. Always turn off the engine before leaving your vehicle.
Key not detected
This message is displayed if the smart key is not detected when you press the Engine Start/Stop button.
Press START button again
This message is displayed if you were unable to start the vehicle when the Engine Start/Stop button was pressed. If this occurs, attempt to start the engine by pressing the Engine Start/ Stop button again.
If the warning message appears each time you press the Engine Start/Stop button, have the vehicle inspected by an authorized HYUNDAI dealer.
Press START button with key
This message is displayed if you press the Engine Start/Stop button while the warning message “Key not detected” is displayed.
At this time, the immobilizer indicator light blinks.
Check BRAKE SWITCH fuse
This message is displayed if the brake switch fuse is disconnected.
You need to replace the fuse with a new one before starting the engine.
If that is not possible, you can start the engine by pressing the Engine Start/ Stop button for 10 seconds in the ACC position.
Shift to P or N to start engine
This message is displayed if you try to start the engine in any other position except P (Park) or N (Neutral).
Information
You can start the engine with the gear in N (Neutral). But, for your safety, we recommend that you start the engine with the gear shifted to P (Park).
Battery discharging due to external electrical devices
This message is displayed if the vehicle battery voltage is low or if a current draw is detected that could drain the vehicle battery.
Check to see that there are no nonfactory external electronic devices connected to the vehicle battery system, otherwise battery discharge may occur.
If this message appears in the LCD cluster and there are no other nonfactory electronic devices connected to the vehicle, have the vehicle inspected by an authorized HYUNDAI dealer.
Hyundai Santa Cruz 2021-2025 Owners Manual: Lane Following Assist Operation
Warning and control
Lane Following Assist
If the vehicle ahead and/or both lane
markings are detected and your vehicle
speed is below 110 mph (180 km/h), the
green indicator light illuminates
on
the cluster, and Lane Following Assist
helps center the vehicle in the lane by
assisting the ste ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Components and Components Location
- Components
1. Rear door trim2. Rear door delta inner cover3. Rear door belt inside weatherstrip4. Rear door module5. Rear door belt outside weatherstrip6. Rear door channel7. Rear door frame garnish [RH]8. Rear door frame garnish [LH]9. Rear door frame garnish10. Rear door window glass run11 ...