Hyundai Santa Cruz: Convenient Features / High Beam Assist (HBA)
.jpg)
High Beam Assist will automatically switch between high beam and low beam depending on the detected brightness from the lamps of oncoming vehicles or vehicles in front.
Detecting sensor
.jpg)
[1] : Front view camera
The front view camera is used as a detecting sensor to detect ambient light and brightness while driving.
Refer to the picture above for the detailed location of the detecting sensor.
NOTICE
- Always keep the front view camera in good condition to maintain optimal performance of High Beam Assist.
- For more details on the precautions of the front view camera, refer to “Forward Collision-Avoidance Assist (FCA)” section in chapter 7.
Lighting
Exterior Lights
Lighting control
To operate the lights, turn the knob at
the end of the control lever to one of the
following positions:
1. OFF position
2. AUTO headlamp position
3. Position lamp p ...
High Beam Assist Operation
Display and control
• After selecting ‘High Beam Assist’
in the Settings menu, High Beam
Assist will operate by following the
procedure below.
- Place the headlamp switch in
the AUTO positio ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Canister
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, canister, fuel tank) when raising the vehicle using
the lift.(Refer to General Information - "Lift and Support Points")
1.Turn the ignition switch OFF and disconnect the batter ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Shift Cable
- Components
1. Shift lever knob & boots assembly2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer
- Removal
1.Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.Remove the air cleaner assembly and air duct.(Refer to Engine ...
